User Manual

6. Make certain the emitter points are straight and paral-

lel to the plane of the fan.

7. Replace the front grill.

Bracket Removal

The IN5120 in-tool ionizing blower can be removed

from the universal bracket by unscrewing the side knobs.

Note that there are washers located between the side

knobs, stand and chassis.

Service

Ptec™ ionizers are reliable products with a long ser-

vice life. If you feel your unit is not operating properly,

turn off the unit and disconnect the power cord. Contact

Transforming Technologies’ Technical Support for repair

assistance.

Troubleshooting

The information below provides a reference for prob-

lems that may arise with your IN5120 in-tool ionizing

blower. If you have other problems not covered below,

please contact Transforming Technologies’ Technical

Support for repair assistance

Problem Causes

 Balance outside Emitter points are dirty, damaged

specifications. or not straight. Clean or replace

 Alarm light activated Low HV output, call for repair

Unit is arcing, call for repair

Short circuit, call for repair