User Manual

Because the IN4000 high voltage output is AC, emitter erosion

from the ionization process on the electrodes is minimal.

Unless physically broken or stressed, the IN4000 emitters

should last the life of the ionizer.

Follow these instructions to remove the emitter points:

1. Turn off and disconnect the unit from the AC power.

2. Remove the output nozzle.

3. Unscrew the emitter point using needle nose pliers.

4. Replace and tighten the new emitter using the same tool.

Do not over-tighten.

5. Make certain the emitter points are straight and undam-

aged.

6. Replace the output nozzle.

Service

Ptec™ ionizers are reliable products with a long service

life. If you feel your unit is not operating properly, turn off the

unit and disconnect the power cord. Contact Transforming

Technologies’ Technical Support for repair assistance.

Troubleshooting

The information below provides a reference for problems

that may arise with your IN4000 ionizing air nozzle. If you

have other problems not covered below, please contact

Transforming Technologies’ Technical Support for repair as-

sistance

Problem Causes

 Balance outside Emitter points are dirty, damaged

specifications. or not straight. Clean or replace

 Alarm light activated Low HV output, call for repair

Unit is arcing, call for repair

Short circuit, call for repair