User Manual

Periodic Maintenance
The only regular maintenance required for the IN4000 is
the periodic cleaning of the emitter point. Emitter point clean-
ing affects the static decay ability of the ionizer and is impor-
tant for maintaining its optimal performance.
Cleaning the emitter points
Contaminants will gradually accumulate on the tip of
the emitter points with continuous use. Periodic cleaning of
the emitter points is necessary to maintain the performance of
the ionizer. If the emitter points are dirty, clean them with a
polyester or cotton swab and IPA. Do not damage or loosen
the emitter points.
Follow these instructions to clean the emitter points:
1. Remove the output nozzle (threaded).
2. Moisten a swab in the IPA solution and wipe the emitter
point until it is free of particles.
3. Make certain the emitter point is straight and undamaged.
4. Replace the output nozzle.
5. Make sure the emitter points are dry before turning on the
power
Emitter Point Replacement
The IN4000 uses tungsten alloy precision etched emitter
needles. Contact Transforming Technologies for information
about ordering replacement emitters. The part number for
emitters is listed below:
Replacement part Part Number
IN4000 tungsten replacement emitters 22-3423
5