User Guide

Creating an FPGA Image DAT File
Appendix D: FPGA Support 205
Note: Datgen.exe only seems to run on a local drive; operating datgen.exe from a network
mapped drive may fail.
Typical output, using the STAPL file: tm_fpga_top.stp file as its input, is shown
below:
C:\>datgen tm_fpga_top.stp
DirectC Version 2.x
Copyright (C) 2002 - 2007 Actel Corporation
Checking STAPL file CRC value..
Actual CRC = 7D55
Reading STAPL file...
Generating .dat files...
Image size = 129680
Data compression = 0
Stapl Target ID = 3A121CF
Tool version = 1
Map version = 1
Core Support = 1
FROM support = 0
NVM support = 0
NVM_Block0 support = 0
NVM_Block1 support = 0
NVM_Block2 support = 0
NVM_Block3 support = 0
NVM verifiy = 0
Pass key support = 0
AES key support = 0
Core security Status = 0
From Security Status = 0
NVM_BLOCK0 Security Status = 0
NVM_BLOCK1 Security Status = 0
NVM_BLOCK2 Security Status = 0
NVM_BLOCK3 Security Status = 0
Image CRC = 244B
Done.
C:\>dir *.dat
03/13/2009 02:15 PM 129,680 tm_fpga_top.dat
1 File(s) 129,680 bytes
0 Dir(s) 23,756,279,808 bytes free
3. The resulting tm_fpga_top.dat can now be loaded onto the M6e-TC using the
process described in
Loading an FPGA Image.