User Guide

FPGA Faults
Appendix C: Error Messages 187
FAULT_PROGRAM_VERIFY_FAILED – 2E2h
Cause
When a boot firmware (0x02) is issued during an FPGA image load and the verification of
the FPGA FlashROM pages fails.
Solution
Power cycle the module and reload the FPGA load application and FPGA image. If
problem persists try a previous version of the FPGA Load Image application with the
same DAT file.
FAULT_PROGRAM_OPERATION_FAILED – 2E3h
Cause
When a boot firmware (0x02) is issued after the FPGA image is loaded and the
verification of the FPGA version and testing of the 16-bit FPGA-ATMEL parallel interface
fails.
Solution
Power cycle the module and reload the FPGA load application and FPGA image. Check
that the FPGA TM and TC version numbers start with 0x1234xxxx and 0x0010,
respectively. If problem persists contact [e-mail].
FAULT_PROGRAM_NOT_LOADED – 2E4h
Cause
When a boot firmware (0x02) is issued and the FPGA DAT file has not been loaded.
Solution
Power cycle the module and reload the FPGA load application and FPGA image. If
problem persists try a previous version of the FPGA Load Image application with the
same DAT file.