User Guide

FPGA Faults
186 Appendix C: Error Messages
FPGA Faults
The following table lists the common faults discussed in this section.
FAULT_PROGRAM_ERASE_FAILED – 2E0h
Cause
When a boot firmware (0x02) is issued during an FPGA image load and the erase of the
FPGA FlashROM pages fails
Solution
Power cycle the module and reload the FPGA load application and FPGA image. If
problem persists try a previous version of the FPGA Loag Image application with the
same DAT file.
FAULT_PROGRAM_FAILED – 2E1h
Cause
When a boot firmware (0x02) is issued during an FPGA image load and the programming
of the FPGA FlashROM pages fails.
Solution
Power cycle the module and reload the FPGA load application and FPGA image. If
problem persists try a previous version of the FPGA Loag Image application with the
same DAT file.
Fault Message Code
FAULT_PROGRAM_ERASE_FAILED – 2E0h
2E0h
FAULT_PROGRAM_FAILED – 2E1h
2E1h
FAULT_PROGRAM_VERIFY_FAILED – 2E2h
2E2h
FAULT_PROGRAM_OPERATION_FAILED – 2E3h
2E3h
FAULT_PROGRAM_NOT_LOADED – 2E4h
2E4h