Datasheet

S
S
S
D
D
D
H
H
H
C
C
C
1
1
1
0
0
0
C
C
C
a
a
a
r
r
r
d
d
d
s
s
s
e
e
e
r
r
r
i
i
i
e
e
e
s
s
s
Rev. 1.0
4~32GB High Capacity Secure Digital Card
Transcend Information Inc.
19
•
WRITE_BL_PARTIAL
This field is fixed to 0, which indicates partial block read is inhibited and only unit of block access is allowed.
•
FILE_FORMAT_GRP
This field is set to 0. Host should not use this field.
•
COPY
Defines whether the contents is original (=0) or has been copied (=1). Setting this bit to 1 indicates that the card
content is a copy. The COPY bit is a one time programmable bit except ROM card.
•
PERM_WRITE_PROTECT
Permanently protects the whole card content against overwriting or erasing (all write and erase commands for this card
are permanently disabled). The default value is ‘0’, i.e. not permanently write protected.
•
TMP_WRITE_PROTECT
Temporarily protects the whole card content from being overwritten or erased (all write and erase commands for this
card are temporarily disabled). This bit can be set and reset. The default value is ‘0’, i.e. not write protected.
•
FILE_FORMAT
This field is set to 0. Host should not use this field.
•
CRC
The CRC field carries the check sum for the CSD contents.
The checksum has to be recalculated by the host for any CSD modification. The default corresponds to the initial CSD
contents.
The following table lists the correspondence between the CSD entries and the command classes. A ‘+’ entry indicates
that the CSD field affects the commands of the related command class.
4. RCA Register
The writable 16-bit relative card address register carries the card address that is published by the card during the card
identification. This address is used for the addressed host-card communication after the card identification procedure.
The default value of the RCA register is 0x0000. The value0x0000 is reserved to set all cards into the Stand-by State
with CMD7.