Computer Hardware User's Manual

HARDWARE INSTALLATION 8
2.6 Memory Configuration
This motherboard must be installed with DIMM (Dual Inline Memory Module). The DIMMs must
be 3.3 Volt synchronous DRAM modules. It also supports ECC (Error Checking and Correct-
ing).
IMPORTANT: Memory speed setup is required through “Auto Configuration“ in BIOS
Chipset Features Setup.
Install memory in any combination as follows:
n DIMM Sockets
PS/2
T:Mouse B:Keyboard
USB
T:Port 1 B:Port 2
COM2 COM1
Printer
Parallel Port
Intel443ZXAGP Set
ATX Power Connector
Primary IDE Connector
Second IDE Connector
Floppy Connector
POWER-FAN
CPU-FAN
FDC
IrDA
Infrared Port
PWR-CONN
KB MOUSE
USB
COMB
COMA
Thermal Sensor
KB-AWK
o
n
P
osition
MM1)
MM2)
MM3)
168-pin DIMM
SDRAM 8,16, 32, 64,128 ,256MBytes
SDRAM 8,16, 32, 64,128, 256MBytes
SDRAM 8,16, 32, 64,128, 256MBytes
768MBytes (MAX.)
DIMM Location
DIMM1
DIMM2
DIMM3
Total Memory
TS-ABX31 168Pi
n
Transcend
AGP
PCI Slot1 (PCI1) PCI Slot4 (PCI4) PCI Slot2 (PCI2) PCI Slot3 (PCI3)
ISA Slot1 (ISA1) ISA Slot2 (ISA2)
IntelPIIX4ChipSet
CR2032 3VLithium Cell
2Mbit Flash (BIOS)
Multi-I/O&KeyboardController
FrequencyDIP Switch
PANEL
Panel Switch
IDE1IDE2
CASE-FAN
PCI1 PCI2 PCI3 PCI4
ISA1 ISA2
WOL
Wake On LAN
AGP
CMOS_CLR
HardwareMonitor
Unbuffered Positio
3.3V
P
168Pin SDRAM Module (DI
M
168Pin SDRAM Module (DI
M
168Pin SDRAM Module (DI
M