User's Manual

9
6. Cautions
Do not use or store the DrivePro™ Body in the following places to prevent malfunction or
deformation:
 In extremely hot, cold or humid places such as in a car parked in the sun
 Under direct sunlight or near a heater
 Near strong magnetic fields
 In sandy or dusty places
Care and storage of the DrivePro™ Body lens
 Wipe the surface of the lens clean with a soft cloth in the following cases:
When there are fingerprints on the lens surface
When the lens is exposed to salty air such as at the seaside
 Store in a well-ventilated location subject to little dirt or dust
 To prevent mold, periodically clean the lens as described above
Cleaning
Clean the DrivePro™ Body surface with a soft cloth slightly moistened with water, then wipe the
surface with a dry cloth. Do not use any of the following as they may damage the finish or the casing:
 Chemical products such as thinner, benzine, alcohol, disposable cloths, insect repellent,
sunscreen or insecticide, etc.
 Do not touch the camera with any of the above on your hand.
 Do not leave the camera in contact with rubber or vinyl for a long time.
Moisture condensation
 If the DrivePro™ Body is brought directly from a cold to a warm place (or vice versa), moisture
may condense inside or outside the camera. This moisture condensation may cause
malfunction of the DrivePro™ Body.
 If moisture condensation occurs, turn off the DrivePro™ Body and wait about 1 hour for the
moisture to evaporate.
Bundled Velcro usage
 The bundled Velcro is recommended for raincoats, windcheaters and other plastic surfaces, but
not recommended for cotton, wool or leather. If you want to use it on such fabrics, please sew it
on.
 Each set of Velcro has two sides. Please adhere one side to the bundled Velcro holder and the
other side to another surface.
 Application instructions: Clean and dry surface before application. Peel tape and press firmly