Brochure
Table Of Contents
92
1
2 3 4
1-1
Practical Examples
TRANSAIR
®
QUICK ASSEMBLY BRACKETS
FITTING
A BRACKET
T
O A PRESSURISED
SYSTEM
TOOLS REQUIRED
PROCEDURE
1 - Position the pressurised system bracket and
tighten with the recommended tightening
torque.
2 - Screw the drilling tool onto the ball valve.
Drill fully.
immediately.
4 - Dismantle the drilling tool.
Under pressure bracket with 1/2" ball valve
Use the under pressure drilling tool (EA98 06 00) to fit a bracket to an existing pressurised
system. This can be simply done with use of a standard drill.
Drill bit
Threaded connector to
screw onto the air intake
Silencer
attachment
point
Tool body
End cap
1-1 Screw the assembly onto the ball valve.
Ensure that the valve is open.
Spacer