Brochure
Table Of Contents
89
5 / 10 N.m
1
2
5 / 10 N.m
5 / 10 N.m
4
3
DRILLING TOOL
FOR ALUMINIUM
PIPE 6698 02 02
FOR Ø25 AND
6698 02 01 FOR
Ø40, Ø50 AND
Ø63.
DRILLING JIG FOR
ALUMINIUM PIPE
6698 01 03
DEBURRING TOOL
FOR ALUMINIUM
PIPE 6698 04 02
PERMANENT
MARKER PEN
DRILL
1 - Mark the pipe at the desired position for
the bracket, using the same locator mark
when several take-off points need to be
aligned uniformly. Place the drilling jig ref.
6698 01 01 in a vice or on the floor.
bolt in the jig using an allen key and place
the pipe in the jig. The locator mark on the
pipe should be aligned with the appropriate
guide marks on the side of the jig.
Two guide lines on either side of the jig
provide a rapid indication of whether the
pipe is correctly positioned (the guide lines
match the locator marks on the pipe).
Close the jig and drill a hole using the
appropriate drilling tool:
>ref. 6698 02 01 drilling tool
NB: drill without lubrication.
swarf and the cut circular piece of pipe.
brackets that you wish to fit.
3 - Position the quick assembly bracket using
its location pin.
TOOLS
REQUIRED
PROCEDURE
Fitting a Quick Assembly Bracket
TO
Ø 25
Ø 40
Ø 50
Ø 63
PIPE
INSTALLATION GUIDE