Brochure

83
1
2
3
4
5
1
2
3
4
5
SYSTEM MODIFICATION
REPLACING
A PIPETOPIPE
CONNECTOR
WITH A TEE
REPLACING
A PIPETOPIPE
CONNECTOR
WITH A BALL VALVE
1 - Loosen the 2 nuts.
2 - Slide them along the pipe on either side of
the connector.
3 - Remove the body of the connector,
together with the nuts. Re-tighten the nuts
on the body of the connector for a further
use.
1 - Loosen the 2 nuts.
2 - Slide them along the pipe on either side of
the connector.
3 - Remove the body of the connector, toge-
ther with the nuts. Re-tighten the nuts on
the body of the connector for a further use.
4 - Slide the nuts of the tee and position the
body of the tee between the 2 pipes such
that the solid and empty arrows are facing
each other.
5 - Re-tighten the nuts until the empty and
solid arrows are aligned with each other.
4 - Slide the nuts of the valve and position the
body of the valve between the 2 pipes so
that the empty and solid arrows are facing
each other
5 - Re-tighten the nuts until the empty and
solid arrows are aligned with each other.
FOR DIAMETERS Ø16.5  Ø25  Ø40 ONLY
FOR DIAMETERS Ø16.5  Ø25  Ø40 ONLY
INSTALLATION GUIDE