Brochure

80
Ø 76
Ø 100
Ø 168
1
3
5
7
2
4
6
8
Connection / Disconnection
To disconnect, perform the same operations in reverse order.
CONNECTION
See Assembly Guide
1 - Slip the cartridge over the end of the first pipe
fully up to the shoulder.
2 - Bring the second pipe to the cartridge and slide
fully up to the shoulder.
3 - Position the clamp over the cartridge / pipe
assembly.
4 - Hand tighten the pre-fitted screws with an Allen
key (6 mm for Ø76 and Ø100, 8mm for Ø168).
5 -
Pull the pipes fully back towards the outside of
the clamp.
6 - Fully tighten the clamp screws.
Mini tightening torque:10Nm
Maximum tightening torque: 40m.N
7 -
For effective clamp sealing, screw tightening
should be performed on alternate sides of the
clamp as shown above.
8 - Check manually with an Allen key that the screws
are correctly tightened.
TRANSAIR
®
PIPETOPIPE & STUD CONNECTORS