Brochure

Table Of Contents

Best Practices

I When installing a Transair

system, the work should be performed in accordance with good

engineering practices.

I Maintain a consistent level of good quality air by use of adequate ﬁltration at the compressor

outlet.

I Never encase the network in order to facilitate maintenance or servicing.

I Bends and bypasses represent sources of pressure drop.

I To avoid excessive pressure loss, use modular consoles to offset the network and to bypass

obstacles.

I Keep in-line pipe diameter reductions to a minimum.

I The diameter of the pipe will inﬂuence pressure drop and the operation of point-of-use equipment.

I Select the diameter according to the required ﬂow rate and acceptable pressure drop at the

points of use.

I Position drops as close as possible to the point of use.

INSTALLATION GUIDE