Brochure
Table Of Contents
18
TRANSAIR
®
Standards Related to Transair
®
Aluminium Pipe
I
Transair
®
aluminium piping system complies with the QUALICOAT label, which guarantees the quality of the
painting process, the chemicals used, the finished quality and the coating resistance of the aluminium
pipe.
I
Transair
®
aluminium piping system complies with EN 755.2, EN 755.8, EN 573.3 standards, which define
mechanical and chemical properties of pipes. The quality and consistency of the aluminium alloy used
allow to bend Transair
®
aluminium pipe as described on page 110 of this catalogue.
Transair
®
aluminium range certifications fall within the standards and regulations universe described on pages 8 and 9 of
this catalogue.
I
Transair
®
aluminium range conforms to ISO 8573: 2001 & 2010 Classes 1.1.1 certification.
ISO 8573 certification establishes the different quality classes of compressed air for the 3 main components
present in any compressed air system: dust, water and grease.
Transair
®
aluminium range has been successfully tested to reach the highest expectation of this standard.
A Transair
®
distribution network guarantees a constant quality of the conveyed fluids, from the production
point to the point of use.
Applications
* : Transair
®
in line with standard after 1 purge ** : Transair
®
in line with standard depending on the atmospheric conditions
ISO 8573-1:2010
Class
Solid Particulate Water Oil
Maximum number of particles per m
3
Mass
Concentration
mg/ m
3
Vapour
Pressure
Dewpoint
Liquid
g/m
3
Total Oil (aerosol liquid
and vapour)
0.1 – 0.5 µm
0.5 – 1 µm 1 – 5 µm
mg/ m
3
0 As specified by the equipment user or supplier and more stringent than Class 1
1 OK* OK* OK*
- OK** - OK
2 OK OK OK - OK - OK
3 - OK OK - OK - OK
4 - - OK - OK - OK
5 - - OK - OK - -
6 - - - OK OK - -
7 - - - OK - OK -
8 - - - - - OK -
9 - - - - - OK -
X - - - OK - OK OK