Brochure

Table Of Contents

137

Best Practices

I When installing a Transair

system, work should be performed in accordance with good engineering practice.

I The diameter of the pipe will inﬂuence pressure drop and the operation of point-of-use

equipment.

I Select the diameter according to the required ﬂow rate and acceptable pressure drop at the point of use.

I Position drops and feeds to take-off points as close as possible to the point of use.

I Bends and bypasses represent sources of pressure drops.

I Keep in-line pipe diameter reductions to a minimum.

I Never encase the network in a hard solid mass, in order to facilitate maintenance or servicing.

I To insulate Transair

industrial water systems thermally, we recommend insulating the Transair

stainless steel pipes.

INSTALLATION GUIDEINSTALLATION GUIDE