Brochure

136
THE GOLDEN RULES OF INSTALLATION
Installation Instructions
When maintaining or modifying a Transair
®
system, the relevant section should be purged prior to the commencement of any
work.
Installers should only use Transair
®
components and accessories, in particular Transair
®
pipe clips and fixture clamps.
The technical properties of the Transair
®
components, as described in the Transair
®
catalogue, must be respected.
Transair
®
pipe should be protected from mechanical impact, particularly if exposed to potential collision with fork-lift trucks or
when sited in an environment with moving overhead loads. Similarly, rotation of the pipe and pipe supports should be avoided.
Transair
®
pipe must not be welded.
NB: For bending a Transair
®
stainless steel pipe, please refer to page 149 of this catalogue.
• Installation within a solid mass (concrete, foam, etc.), especially underground
• The suspension of any external equipment from Transair
®
pipe
• The use of Transair
®
for earthing, or as a support for electrical equipment
• Exposure to chemicals that are incompatible with Transair
®
components (please contact us for further details).
• Use of components not approved by Transair
®
Transair
®
components are provided with assembly instructions for their correct use - simply follow the methods and
recommendations stated in this document or separate data sheets.
I General
I Transair
®
Pipe and Hoses
I Transair
®
Installations - Prohibited Situations
Once the Transair
®
system has been installed and prior to commissioning, the installer should complete all tests,
inspections and compliance checks as stated in any contract and according to sound engineering practice and current local
regulations.
I Commissioning the Installation
I Component Assembly