User's Manual

Step-by-Step Installation Procedures
Page 20 100-TBD - Rev A
Connecting the Communication Cable
The Printrex
®
920 is equipped with two interface ports. These interfaces are:
x USB 2.0 High Speed
x Ethernet 10/100 Base TX
Connect the appropriate communications cable to the corresponding port on
the printer as shown in the following figure. Cables are provided by your
dealer, the system installer or are available through Printrex.
Connect the cable to the printer first, as shown in the figure, and then to the
computer.
Note: You can disconnect the USB cable even while the printer and computer
are on, but do not disconnect the USB cable in the cases described below.
This could prevent the printer from operating normally.
x While the computer is starting up (until the desktop display appears).
x While the printer is printing.
x While you install the printer driver.
To disconnect the USB cable while the computer and the printer are on,
disconnect it at the computer or the USB hub. To reconnect the USB cable,
wait at least 5 seconds before you connect it again. If you reconnect it
immediately, the printer may not operate correctly.
Note: A USB cable is not provided with the printer. Please prepare a cable
that matches the port on your computer.
Note: Please consult your network administrator when connecting to an office
LAN using an Ethernet cable.
Note: If a printer driver has not been installed in the computer to which you
want to connect your printer, install it before connecting the USB cable or LAN
cable.