Installation Guide
Table Of Contents
- Table 1: Revision History
- DR5000 Reader Installation Guide
- Mounting Options
- Figure 1-3 Figure 1-3 DR5000 Mounting Options
- Detailed Installation
- 1 For installations without a trim plate, use the mounting plate as a guide to drill mounting holes and cable route opening in the mounting surface.
- 2 Route cable through opening or to the single gang box, see wiring tables on step 6.
- 3 Install the trim plate if applicable.
- 4 Install the mounting plate.
- 5 Connect the wires to the terminal blocks. Refer to tables 2 and 3 for wiring connections.
- Table 1-2: Figure 1-5 TB1 Connections
- Table 1-3: Figure 1-6 TB2 Connections
- 6 Plug the terminal block(s) onto the pins of the DR5000 Reader; and the terminal blocks in the proper locations.
- 7 Place the reader just above the mounting plate, and then slide down to engage the tab into notch on the back of the reader.
- 8 Secure reader using the tamper resistant security screw (3/32" tamper hex).
- Figure 1-4 Figure 1-8 Tamper Resistant Security Screw
- Reader Configuration
- Reader Testing
- Troubleshooting
- Specifications
DR5000 READER INSTALLATION GUIDE
403-003-001 Rev A
3
Hardware Kit and Parts List
Table 1-1: Table 1-1: Hardware Kit Parts List
NOTE: A single installation does not use all the hardware included.
Figure 1-2 DR5000 Hardware Kit
Item No. Part Number Description Qty
1 044-024-019 1 X 4, 3.5MM TERMINAL BLOCK 2
2 044-028-C07 M2 X 5 18-8 SS BUTTON-HEAD SOCKET CAP SCREW 1
3 044-028-E32 6-20 X .5 PH PHILLIPS SELF DRILLING 2
4 044-028-E39 6-32 X 3/4 TRUSS HEAD PHILLIP MACHINE SCREW 2
5 044-030-101 M2 STAINLESS STEEL FLAT WASHER 1
6 044-059-122 DR5000 WALL MOUNT BRACKET 1