Owners manual
Bolt mount to
engine using (3)
3/8-16 X 1” Gr 8
bolts and lock
washers.
Engine Mount
Bracket #4426
(right)
Engine Mount
Bracket
#4426
(left)
Install new
7/16-14 X 5”
Gr 8 bolts,
lock washers,
flat washers,
and lock nuts.
V6 engine
rubber mount
pads Trans-
Dapt #4217
Special Note: The components packaged in this kit have been assembled and machined for a specific type of conversion.
Modifications to any of the components will void any possible warranty or return privileges. If you do not fully understand
modifications or changes that will be required to complete your conversion, we strongly recommend that you contact our
sales department for more information. This instruction sheet is only to be used for the assembly of Trans-Dapt
Performance components. We recommend that a service manual pertaining to your vehicle be obtained for specific torque
values, wiring diagrams and other related equipment. These manuals are normally available at automotive dealerships and
parts stores.
V6 engine
rubber mount
pads Trans-
Dapt #4217
PART# 4606 & 4626
MOTOR MOUNT
BRACKETS
(4606 WITH PADS)
CHEVY 4.3L V6 ENGINE INTO 2.2 OR 2.8L
TWO-WHEEL DRIVE 1982-1999 CHEVY S-10 & GMC S-15
DAPT
DAPTDAPTDAPT
PERFORMANCE PRODUCTS
INSTALLATION INSTRUCTIONS
These engine mounts are designed to bolt over the original S10 2.2 or 2.8L V6 engine rubber motor
mounts. When used with the TH350 transmission or the original T4/T5 manual transmission, drive shaft
modifications will not be required. The engine mounts work best by first installing the welded mount
brackets over the V6 rubber motor mounts (leave engine bolts loose for adjustability later). Install the
special 7/16” hex head bolt through the Trans-Dapt Performance Part #4217 motor mount. Once the
mounts are installed, the engine can then be positioned into the chassis for final assembly using the
slotted holes on the engine. Tighten all bolts.
Qty. Part No. Description
1 4626 Pair of Engine Mount Bracket
6 HDW366 3/8 - 16 x 1” Grade 8 Hex Head Bolts
6 HDW321 3/8” Lock Washers
2 HDW969 7/16” - 14 x 5” Grade 8 Head Bolts
2 HDW421 7/16” Flat Washers
2 HDW422 7/16” Lock Washers
2 HDW053 7/16” - 14 Lock Nuts
2 4217 Mount Pads (4606 Only)
4606-4626-Instructionsheet-032205.cdr
12438 Putnam Street Whittier, CA 90602 tel (562) 921-0404 fax (562) 921-7515
website: www.tdperformance.com email: techsupport@tdperformance.com
THIS KIT INCLUDES:
CHEVY V6 4.3L