Owners manual

DAPT
DAPTDAPTDAPT
PERFORMANCE PRODUCTS
4558 4538 -
4559 -
9444 -
6538 6558 -
6559 6539 -
6544 6524 -
Straight Universal Crossmember
Universal Crossmember
Straight 700R4, 4L60E&T56
3” DROP 700R4, 4L60E&T56
6” DROP 700R4, 4L60E&T56
4539 3” DROP Universal Crossmember
9424 6” DROP
INSTALLATION INSTRUCTIONS FOR UNIVERSAL TRANSMISSION CROSSMEMBERS
4539-Instructionsheet-111506.cdr
12438 Putnam Street Whittier, CA 90602 tel [phone] fax [phone]
website: www.tdperformance.com email: [e-mail]
1.
2.
3.
4.
Designed to t in “open channel” frames.
Minimum measurement between rails is 26” Maximum measurement is 36”.
Because the mount is universal, portions of the center tube may need to be trimmed so that when the end caps are
installed, the crossmember will t the width of the frame rails precisely.
If your crossmember did not includeapad or you needareplacement, GM, mopar, auto and manual transmissions,
use Trans-Dapt #9442 . For Ford transmissions use Trans-Dapt #4716 rubber steel pad (sold
separately).
rubber steel pad
PART#
w/ Pad
PART#
w/o Pad
Design varies by
part number.
Figure “A” Figure “B”
Design varies by
part number.
Crossmember
Frame