Owners manual

HOOD LOCK SET
INSTALLATION INSTRUCTIONS
Part # 4062
1. Locate a convenient point on the hood directly over a horizontal
surface below the hood such as a radiator core support. This must
be a solid surface for a secure fit. Use rubber gasket as a
template and drill 3/4" hole in hood.
2. Close hood and carefully mark a center hole on the horizontal
cross piece inside hood compartment directly below larger center
hole. Drill 3/8" hole for striker bolt.
3. Adjust striker bolt to allow 3/4" from top of striker to outer hood
panel. Align in top bolt to accept pin at base of lock.
4. Install stainless plate, gasket and lock from outer part of hood. On
inside of hood, install special lock washer and tighten 3/4" nut.
5. Align indicator dog key with notch in lock spindle, depress key and
rotate clockwise to lock, counter-clockwise to unlock.
6. Repeat operation on other side of hood to install second hood
lock.
7. Hood locks are pin lock tumbler actuated circumferential locks,
use only special lock lubricants.
4062-Instruction Sheet.cdr
WARNING: THIS PART DOES NOT
REPLACE STOCK HOOD LATCH!
12438 Putnam Street Whittier, CA 90602 tel [phone] fax [phone]
website: www.tdperformance.com email: [e-mail]
Use loctite
on all threads
HOOD LOCK SET
INSTALLATION INSTRUCTIONS
Part # 4062
1. Locate a convenient point on the hood directly over a horizontal
surface below the hood such as a radiator core support. This must
be a solid surface for a secure fit. Use rubber gasket as a
template and drill 3/4" hole in hood.
2. Close hood and carefully mark a center hole on the horizontal
cross piece inside hood compartment directly below larger center
hole. Drill 3/8" hole for striker bolt.
3. Adjust striker bolt to allow 3/4" from top of striker to outer hood
panel. Align in top bolt to accept pin at base of lock.
4. Install stainless plate, gasket and lock from outer part of hood. On
inside of hood, install special lock washer and tighten 3/4" nut.
5. Align indicator dog key with notch in lock spindle, depress key and
rotate clockwise to lock, counter-clockwise to unlock.
6. Repeat operation on other side of hood to install second hood
lock.
7. Hood locks are pin lock tumbler actuated circumferential locks,
use only special lock lubricants.
4062-Instruction Sheet.cdr
WARNING: THIS PART DOES NOT
REPLACE STOCK HOOD LATCH!
12438 Putnam Street Whittier, CA 90602 tel [phone] fax [phone]
website: www.tdperformance.com email: [e-mail]
Use loctite
on all threads
DAPT
PERFORMANCE PRODUCTS
DAPT
PERFORMANCE PRODUCTS