Owners manual

Billet-Wheel-Adapters-012407.cdr
IMPORTANT NOTES - READ FIRST
12438 Putnam Street Whittier, CA 90602 tel [phone] fax [phone]
website: www.tdperformance.com email: [e-mail]
DAPT
DAPTDAPTDAPT
PERFORMANCE PRODUCTS
BILLET WHEEL ADAPTER
INSTALLATION INSTRUCTIONS
1. ,
2.
6.
7.
8.
Check wheel for burrs, rivet heads remove any rust on rotors/drums or other obstructions which
could prevent proper seating of the adapter.
Check that wheel and tire clearance allows for full steering (lock-to-lock). Check for adequate tire-
fender clearance when vehicle is loaded.
Balance wheels.
Check and re-torque all bolts every 2000 miles.
4.
All parts must be installed by a qualified technician. Please refer to correct service manual when
lifting your vehicle. Hand torque all lug nuts to factory specs.
Raise vehicle off ground and place jack stands under lift points.
Remove wheels.
N This would be a good time to check your vehicle for any necessary service it may require in
this area. (i.e. wheel bearings, brake components and any other parts in this general area).
Please refer to drawing for guidance. Reinstall your parts back on your vehicle following the correct
procedure and specs on service manuals.
3.
ote:
5.
PRODUCT DISCLAIMER
1.
2.
3.
4.
5.
DO NOT ATTEMPT TO MODIFY ADAPTER. NEVER REMOVE FACTORY INSTALLED STUDS. Alteration or
improper installation is dangerous and will void warranty.
DO NOT USE IMPACT WRENCH.
MAG WHEEL NUTS - Check thread and length. Nuts must not bottom out on adapter before wheel is tight.
Any nuts used must have minimum of 9/16” effective thread length. On open-end lug nuts, the end of the lug
bolt must be flush or extend beyond the lug nut.
Modified vehicles may not meet local and state requirements for use on public streets. It is your responsibility
to adhere to federal, state and local laws prior to installation. It is your sole responsibility to comply with all
laws.
There is no warranty stated or implied due to unusual use or driving conditions, any damage caused by
modifications, improper installations, or improper use is the sole responsibility of you, the buyer (not the
manufacturer, distributor, or retailer). The buyer will assume any cost of any necessary repairs, or services.
We do not guarantee the ride quality of wheel spacers or wheel adapters. Ride quality is an entirely
subjective opinion and there are too many factors that can effect it.
DO NOT USE ON TRAILERS OR FRONT WHEEL DRIVE VEHICLES.
6.
7.