User's Manual

M-FALCON2 Rev B

Troubleshooting the

Falcon PLUS™ System

INTERFERENCE

If interference such as lines in the pictures is observed,

changing the transmission channel may cure the

problem.

Also, AC generators in close proximity to the transmitter

or receiver may cause lines in the picture. Move the unit

away from the source of the interference.

NO PICTURE

Check that the transmit and receive channels are set the

same, and make sure the transmitter is not in Standby

mode (slow, blinking LED), or that the battery is not low

(fast, blinking LED).

Verify all connectors are tight.

POOR PICTURE QUALITY

Raise transmitter and receiver antennas above ground

and away from obstacles and traffic, including foot traffic.

Use an optional high-gain dish antenna on the receiver.

Verify all connectors are tight. Shorten the receiver

antenna feed cable.

VIDEO TOO DARK

Make sure that any monitors/peripheral equipment

connected to the video source are set to high impedance

termination since the VTX5900 has a built-in 75Ω

termination.