User's Manual

M-FALCON2 Rev B

To enter RSSI mode, hold down the Toggle/RSSI button

for 2 seconds. To exit, depress the button momentarily.

The number of LEDs lit is a relative indication of signal

strength to be used only to find the best antenna

position. Viewing the received picture quality should be

used in conjunction with this mode.

Data Pass-Through Mode:

The transmitter and receiver can be used to pass user

data one-way from the VTX5900 to the VRX5900 at

rates from 1200 to 9600 bps. (For optimum data

transmission without losses, both the transmitter and

receiver should be configured to pass or accept data at

the same rate. The data rate can be configured using

the TrangoLink software.) To enter Data Pass-Through

mode, the Stereo/Alarm switch should be placed in

“Alm/Data Mode On.” Then, from the TrangoLink

software, select “Pass-Through Mode.” Make sure both

the VTX5900 and the VRX5900 have been configured

for Data Pass-Through mode. The Right Audio channel

will be disabled in this mode while the Left Audio

channel can still transmit monaural audio. Alarms and

Link Verification cannot be transmitted when in Data

Pass-Through mode. Do not use CBLDAT-1 to send or

receive data since it contains extra wires not used for

normal data transmission.

Please see the pinout diagram in Figure 3 for more

information on wiring the data connector for RS-232.