User's Manual

M-FALCON2 Rev B

commands that control settings in the receiver not

available via the front panel. See the TrangoLink

software program help for more information. This port is

also used for Data Pass-Through mode for RS-232

signal levels.

7. VIDEO OUTPUT

Designed to mate to a standard BNC male connector,

this provides a 1 Volt peak-to-peak video signal output.

This must be terminated with 75Ω. RCA to BNC

adapters are available for use with some monitors and

VCR inputs.

8. TOGGLE/RSSI

To change the receiver channel, depress this switch

momentarily. Remember to change the transmitter

channel as well since it is not automatically changed.

To enter RSSI (Received Signal Strength Indicator)

mode, hold down this button for 2 seconds. The number

of channel LEDs lit is an indicator of signal strength,

which can aid in finding the best antenna position.

9. CHANNEL LEDs

These LEDs display the current receiver channel and act

as a Received Signal Strength Indicator.

CAUTION

DO NOT APPLY EXTERNAL VOLTAGES TO THE

ALARM OUTPUTS. PERMANENT DAMAGE TO THE

UNIT MAY RESULT.