User's Manual

M-FALCON2 Rev B

VTX5900 Transmitter Inputs & Controls:

1. POWER INPUT

Accepts a 6-12 Vdc power source such as the standard

7 Vdc adapter (Trango part number PT07800-1), or an

optional battery. The nominal current draw is 200

milliamperes. If using an adapter from a third party, use

a well-regulated 300 mA minimum output supply. Do

not use the PT07800-1 to power a camera or video

distortion may occur.

2. ALARM INPUTS

These inputs are used to send alarm signals to the

receiver. They sense an open or closed state and reflect

that state to the receiver whenever it changes. The

alarm inputs operate independently of each other. The

transmitter is capable of sending either alarms or stereo

audio, selectable via the Stereo/Alarm switch. If you wish

to use the audio feature and alarm, you will send only

mono audio.

3/4. RIGHT & LEFT AUDIO INPUTS

Designed to mate to standard RCA connectors, each

input accepts 1 Vpp audio input and is terminated with

600Ω unbalanced configuration. It is designed to

interface to “lineout” audio sources. A preamplifier must

be used to connect a microphone to this input.

5. STEREO/ALARM SWITCH

When this switch is in the “R Audio On” position, stereo

audio transmission is enabled. This permits the

transmission of stereo audio with no data or alarms.

When it is in the “Alm/Data Mode On” position, R audio

is disabled. In its place, either alarms or user data (Data

Pass-Through mode) are transmitted. Trango Systems’

MIC-001 can be used for audio transmission.