User Manual

1• Verify proper operation of camera and monitor/event recorder using coaxial cable prior

to installing wireless link.

2• Install transmitter and receiver units in desired location to 2 3/8” diameter steel pole per

installation drawing. The pole must be securely mounted so that it does not move.

3• Install antennas above the enclosures and position as shown in Figure 2.

WARNING

WARNINGWARNING

WARNING

USE EXTREME CARE WHEN INSTALLING ANTENNAS NEAR POWER LINES.

4• Slide heatshrink over antenna cable. Tighten antenna cable to receiver and transmitter.

Heat up the heatshrink until it contracts around the connector junction..

5• Connect video, audio, power, alarm, PC interface cables as needed to units through

flanges. Tighten flanges to allow small air gap at bottom of enclosure.

IMPORTANT NOTE:

Power adapter must be kept dry.

6• Verify that LEDs are lit up and transmitter and receiver are on same channel.

7• Tighten lid of enclosure down.

CAUTION

CAUTIONCAUTION

CAUTION

DO NOT APPLY POWER TO THE TRANSMITTER UNLESS THE ANTENNA IS

CONNECTED. PERMANENT DAMAGE MAY RESULT.