User Manual

Copyright © 1999 Trango Systems, Inc. All rights reserved.
17
ALARM SECTION:
Input Level: Normally open contact closure input on both Alarm 1 and Alarm
2. The current state of the input (open or closed) is transmitted
to the receiver which reflects the transmitter alarm input states.
DO NOT APPLY VOLTAGES TO THESE INPUTS AS
DAMAGE TO THE UNIT WILL OCCUR.
Min. Alarm Duration: 1/2 second minimum to allow detection.
Max. Wire Length: 1000 ft from sensor to alarm input(s)
POWER SECTION:
Input Voltage: 7 Vdc nominal, 6-12 Vdc range
Current Consumption: 150 mA typical in normal mode, 10 mA in Standby mode
Max. Ripple Output: 2 Vpp
Low Battery Sens.: < 6 Vdc