User Manual

Configuring the EAGLE Receiver:

Via the TrangoLink interface panel for the VRX2400 receiver, the user can configure the

following settings:

Link Verification: This is a 32-bit code sent from the transmitter to the receiver to

verify that the signal is being received from the proper location.

Alarms and Alarm Log: Via TrangoLink, the alarm log can be viewed, printed, or

saved to a file. You can also set which of the alarms are active, clear alarms, and

whether the alarms activate open or closed.

Active Channel and Channel Switching: This must be the same on the transmitter

and receiver in order for video to be transferred properly. Automatic channel

switching can also be configured to monitor several transmitters at once. Channels

can also be switched manually using TrangoLink.

RSSI: Used for receiver only to monitor the radio spectrum. Presents a histogram.

Useful in troubleshooting to determine if any other signals are present in the

frequency band.

Low Battery: Whether or not the battery is below voltage on the transmitter and is

hence in danger of failing.

In Fig. 7, the TrangoLink

interface screen shows that the

receiver is set to Channel 12, and

is showing an alarm condition in

Alarm 2, and a low battery

condition on the transmitter.

Fig. 7