User Manual

Copyright © 1999 Trango Systems, Inc. All rights reserved.
13
Overview:
TrangoLink™ allows you to configure and monitor your EAGLE, FALCON, or PTZ-900
transmitters and receivers. On the EAGLE and FALCON transmitters, you can change
the active channel, operating mode, and alarm triggering. On the EAGLE and FALCON
receivers, you can change the active channel and monitor the signal strength, transmitter
battery status, video loss, and alarm status. On the PTZ-900 transmitter and receiver, you
can configure the hopping sequence, the data rate, the mode, and the address as well as
monitor the signal strength.
PC Requirements & Installation:
In order to run TrangoLink, you will need Windows 95 or higher, 400 kB of free disk
space, and one free serial port.
To install (see Fig. 4):
1. Start Win95 (or higher).
2. Click on Start, then Run.
3. Type a:\setup, then click OK.
To uninstall (see Fig. 5):
1. Click on Start, then Settings, then Control Panel.
2. Double click on Add/Remove Programs.
3. Select TrangoLink, and click Add/Remove.
Fig. 4 Fig. 5