User's Manual

Trango Systems, Inc. StrataPro 24 Quick Start Guide 14
4) Install the ground wire to earth ground on the pole or building structure. Use a
minimum 10 AWG grounding cable with #10 Spade Lug, maximum length 1 m/3
feet
5) Run the Ethernet/PoE Cable through the port cover/cord grip as shown below
then connect to the radio Port 1 (Built In RJ45).
6) Power up the radio by first plugging the cable into the PoE Unit, then plugging
the PoE unit into the AC power source. Connect the Data Port of the PoE on one
radio to a laptop computer or switch.
7) Align the radios using the BNC RSSI output or RSSI LEDs to obtain the expected
RSL. The antenna beamwidth is 3.5 degrees in both the horizontal and vertical
directions.
8) Link LED should light up solid green on both ends when the radio is locked on the
RF signal.
9) Verify both radios are reachable by pinging the IP address of the radio units.