User Manual

Getting Started
Trango Broadband Wireless — User Manual Access5830 Rev. D
Page 4
Figure 2-3 Back of Radio
Figure 2-4 Side of Radio & Location of Reverse Polarity SMA Connector
Insert picture of side of radio showing rev. polarity SMA Connector
Section 3 Getting Started
This section explains how to power your radios, establish TCP/IP connectivity to the radios, as well as how to access the HTTP
browser and the command line interfaces.
Connections and Power
Connection and powering of radios is the same for APs and SUs.
?? Connect a Cat-5 (straight through) Ethernet cable (we recommend shielded twisted pair) between the ODU (out door unit)
port of the J-box and the RJ-45 connector on the radio. Note that this cable will carry power over Ethernet (PoE).
?? If connecting to a COMPUTER, use a Cross-Over Ethernet cable from the NET port of the J-box to the computer’s Ethernet
port.
If connecting to a HUB, SWITCH, or ROUTER, use a Straight-Thru cable.
?? Plug the AC adapter into an AC outlet.
Trango Broadband Wireless
M9000S-AP Rev. A
S/N: 00000XXXX
MAC: 00 01 DE 00 02 F3
FCC ID: NCYM900SAP
Canada: XXXXXXXXXX
This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules. These limits are