User Manual
Basic Configuration via Browser Interface
Trango Broadband Wireless — User Manual Access5830 Rev. D
Page 16
Channel Table: Assigns channel numbers to actual frequencies of operation. Default settings allow the largest number of
channels (4) within the band, while still maintaining 6 MHz channel spacing.
Other Key Parameters
This section describes the remainder of the parameters listed on the System Information page. Most of these parameters are the
same for both APs and SUs.
Hardware Version: Hardware version is factory-set and can not be changed by user.
FPGA Version: Low level field programmable gate array firmware currently loaded on the radio. Normally the FPGA firmware will not
require upgrading.
Firmware Version: Main firmware. In this example, the version part of the string is 0p1 (v0.1) , the hardware code is H8005, and the
remainder of the string is a date code.
Device ID: MAC address of the radio.
S/N: Serial number of the radio.
Telnetd Port: User changeable telnet port of radio.
TFTPd: Current status of TFTP daemon. Used for uploading firmware.
MIR Threshold: Enable/Disable the Maximum Information Rate (MIR) Threshold. The MIR Threshold is the aggregate throughput on
the AP at which the AP will start to enforce CIR rules for SUs.
Active Channel: The channel currently being used by the radio.