User Manual

Basic Configuration via Browser Interface
Trango Broadband Wireless — User Manual Access5830 Rev. D
Page 13
Configure Basic SU Parameters
In order to establish a working link, the Base ID in the SU must match the Base ID of the AP
To set up the SU, complete the following steps:
1. Connect to the SU (see Getting Started) and open the Configuration page.
2. Set Base ID (Must match the AP)
3. Set IP, Subnet, and Gateway (Not essential for a link)
4. Set Default Opmode to "ON"
5. Save and Activate Settings
6. Reboot System (This will terminate your HTTP session)
At this point, if all parameters have been set correctly, and if the radios are within range – a wireless link between the AP and SU will
automatically become established.
LED Summary
At this point it is useful to learn about the various LEDs which can be found on the bottom of the radio These LEDs can assist the
user in determining radio and link status.
It should be noted, however, that in “Survey” mode, no LEDs shall light up except the LNKST and ACTST LEDs. The unit shall have
LED indicators to indicate the following:
a) 10/100 LED
Green: Illuminated when link speed is negotiated at 100 BaseT. It is off when link speed is 10 BaseT.