User Manual

Basic Configuration via Browser Interface
Trango Broadband Wireless — User Manual Access5830 Rev. D
Page 12
2. Set Base ID (Must match the SU)
3. Set AP ID (used to identify the AP, not essential to establishing a link)
4. Set IP, Subnet, and Gateway (Not essential for a link)
5. Set Default Opmode to "ON"
6. Set Active Channel
7. Set Antenna Polarization (H or V) or choose E for external antenna
8. Save and Activate Settings
9. Reboot System
At this point the AP will begin actively searching for any SU in its SU database. Once an active SU is detected, the authentication and
association process will begin. The red LED on the bottom of the AP should be lit, indicating that the radio is in Opmode “AP” and
transmitting.