User Manual

Getting Started
Trango Broadband Wireless — User Manual Access5830 Rev. D
Page 8
Logout: This link will end the current HTTP session with the radio.
Help: The Browser Interface features useful Help pages which explain all listed parameters. To access the help pages click on the
Help link.
For a complete description on use of the Browser Interface, see Appendix A.
Command Line Interface
Although most radio functions can be managed via the browser interface, the command line interface (CLI) does provide slightly more
functionality. The CLI can be accessed through Telnet.
Telnet
Open a command prompt (DOS) session on your PC. Open a Telnet session by typing:
telnet [ip address of radio]
Example:
C:>telnet 192.168.100.100
All Trango radios (AP and SU) come factory pre-configured with a default IP address 192.168.100.100. In Telnet, you will be greeted
with current hardware and firmware information and prompted for a password. Type in the password and press enter. The factory
default password is trango.
To terminate a CLI session (Telnet or Serial) type the command logout.
? Note: Type help, or ? for a listing of all CLI commands. Type help <command> for the syntax of a particular command.
The majority of the CLI commands will be covered throughout this text as well as in Appendix B on the Command Set Reference.
Troubleshooting
If you can not telnet into the radio or open an HTTP browser session, check cable connections, ensure proper use of cross-over vs.
straight-through cable, ensure PC’s subnet is routable to radio’s IP address. If you can still not access the radio’s management
interfaces, consult the troubleshooting guide which is available at www.trangobroadband.com in the Technical Support area of the
website.
Reset Button
M900S APs and SUs feature a reset button (located under the translucent plug which can be pressed with a small object such as a
paper clip. Pressing the reset button will reset all of the radio’s parameters (including IP address and passwords) to factory default
192.168.100.100 and password trango. The reset button can be useful if you forget or are unsure of the radio’s IP address/password.