User Manual

Getting Started
Trango Broadband Wireless — User Manual Access5830 Rev. D
Page 7
Figure 3-3 Web Browser System Information Page
Figure 2-3 shows system information for an Access Point. Basic system information for a subscriber unit is similar and is covered in
detail later in this text.
The following describes the primary features and pages of the HTTP Browser interface:
Navigation Column: Each page features a navigation column which runs along the left-hand side of the page. The model number of
the radio is listed at the top of the navigation column. On the bottom of the navigation column is the Current Status of the radio
including its Base ID, current Opmode, channel, antenna selection, and frequency.
The navigation column also features links to each of the following pages:
System Information: This page shows most of the basic configuration parameters of the radio. It is the first page shown after login.
Configuration: The essential parameters, such as Base ID, channel and polarization are set here.
Advanced Setup: The advanced RF parameters, such as transmit power are set here.
Site Survey: From here, in Opmode Off, the user can conduct a spectrum analysis.
Subscriber Database: This is the page for defining which SUs can associate to the AP.
Link Control: This page shows which SUs are associated. This page also provides several tools for evaluating the quality of the
wireless link.
Command Console: From this page, the user can run any console command which is not interactive (i.e. ipconfig). The results are
reported back via HTTP screen. For a complete list of console commands, type "help" or “?” in the entry field.