Prof Install Guide for M900S Access Point and Subscriber Unit M900S™ Wireless Broadband System PROFESSIONAL INSTALLATION GUIDE FOR M900S-AP and M900S-SU [draft] 1
Prof Install Guide for M900S Access Point and Subscriber Unit 1. Overview This manual covers configuration and installation of the optional external antennas for use with the M900S Access Point M900S-AP and Subscriber Unit M900S-SU. Since this device requires manual power limit settings for use with the higher gain antennas, it is classified by the FCC as a professional install device.
Prof Install Guide for M900S Access Point and Subscriber Unit 4. General Information 4.1 Contents Each SU or AP radio comes equipped with an intenal dual polarization antenna, a power-over-Ethernet (POE) J-Box, an AC adapter, and mounting hardware for pole mounting. The radio also has one reverse-polarity SMA connectors on the side for attachment to an external antenna. The MAC ID and Serial # are printed on a label on the back of the radio. 4.
Prof Install Guide for M900S Access Point and Subscriber Unit 6.0 INSTALLATION INSTRUCTIONS The radio unit may be installed on a pole or a flat surface per the drawing below: WALL MOUNTING POLE MOUNTING TO ANTENNA TO ANTENNA BRACKETS (SUPPLIED) BOLTS FOR MOUNTING TO WALL NOT SUPPLIED Please see the M900S User Manual for instruction on grounding and weatherproofing the installation.
Prof Install Guide for M900S Access Point and Subscriber Unit 6.1 Yagi Antenna To install the Cushcraft Yagi PN # PC9013N antenna please see the drawing below Add Drawing of antenna mounting 6.2 Omni Antenna To install the Comtelco PN #BS915XL7 antenna, please follow the instructions below. These antennas recommended for access points only, but may be used with subscriber units. Insert Omni mounting picture 7.
