User's Manual

Using the HTTP Interface
M5580M-FSU page 17
Configure Basic Cont.
5. Entered Base ID , AP ID (not required for establishing a link), and SU ID
(This settings must match those entered on the AP for this unit.)
6. Click on “Change IDs”
7. Configured Default Opmode to “SU” (This will ensure that your SU will establish a link when the power is cycle.)
8. Enter Channel(s) and Polarization(s) “Scan AP Sequence.”
(The SU will use these entries to look for an AP to link up to)
9. Click on “Save and Activate Settings”
10. Click on Activate Opmode.