User's Manual

Using the HTTP Interface
M5580M-FSU page 15
Chapter 4 Using the HTTP Interface
This section describes a few more basic concepts and how to establish a basic wireless link with the AP,
using the Browser (HTTP) Interface. This section addresses only the most basic steps in establishing a link in the
lab, or
a bench-top environment. It is highly recommended that you read the Access 5830 Users Guide to gain an
understanding of all important configuration parameters and procedures prior to deploying any wireless
equipment.
Configure Basic Parameters
Each SU must be set up with basic information to communicate with the AP. At a minimum the Base ID must
match
the Base ID of the AP, the SU ID must match the SU ID in the AP.s SUDB, and the AP.s active channel must
exist
in the SU.s AP Scan Sequence.
To set up the SU, complete the following steps:
1. Connect to the SU (see Chapter two “Getting Started”), and open the Configuration
page.
2.
Open a browser session and type in the IP address of one of the radios. Default IP address is
192.168.100.100.
3. Leave the User name field blank and enter read write or read only Password. Press OK. Default
password is trango. After logging on, the system information screen will be displayed.