User's Manual
Trango Broadband Wireless — User Manual M2400S Rev. A
Page
44
Command Radio Description Access
targetap SU Display the SU current setting for target AP ro/rw
targetap all SU SU will associate with any AP with the same BaseID
“all” is the default setting.
rw
targetap only <mac1, hex> [<mac2, hex>] SU SU will only associate with AP with specified MAC addresses. rw
targetrssi AP Display SU target rssi in dBm. This setting is used in the SU
powerlevelling process.
ro/rw
targetrssi <dBm, -90..-50> AP Change target rssi. Note: target rssi must be +5 dB more than
rfrxth (RFRX Threshold).
default = -60
rw
tftpd AP/SU display current tftpd status (status is either on or off) This
command will also list any contents of the TFTP buffer.
ro/rw
tftpd <on | off> AP/SU enable or disable tftpd service. TFTPD must be on in order to
upload new firmware or new sudb file.
rw
updateflash <systemsetting | ss> AP/SU Save current settings. This command can be issued in
several ways:
save ss, updateflash systemsetting, save systemsetting, and
updateflash ss
rw
updateflash <mainimage | fpgaimage>
<current chscksum> <new checksum>
AP/SU Retrieve uploaded firmware from tftp buffer, verify checksum
and write to flash memory at main or fpga image section.
rw
updateflash sudb AP Save su dbase into flash memory rw
ver AP/SU display firmware and date codes
1. version number and date code
2. firmware and fpga version code
3. firmware and fpga image checksum
ro/rw