User's Manual

Trango Broadband Wireless — User Manual M2400S Rev. A
Page 43
Command Radio Description Access
18. tcp ip service for Ethernet port on/off
19. default channel and antenna
20. active channel and antenna
21. tx power
22. remarks
23. RF tx retry at AP, RF tx retry maxed out at AP
RF tx retry at SU, RF tx retry maxed out at SU
su ipconfig <suid> <new IP> <new
subnet> <new gateway>
AP Change IP, subnet, gateway for specified SU rw
su linktest <suid> AP Sends 100 1600 byte packets 10 times and reports back the
average throughput.
ro/rw
su ping <suid> AP Request SU’s ranging and rssi information ro/rw
su reboot <all | suid> AP Reboot a specific SU or all SUs rw
su testrflink <suid> [r] AP Sends 20 1512 byte packets to <suid> and listens for the
response back
r: will repeat until user presses space bar
Ro/rw
sudb add <suid> <pr|re> <mac> AP Add new SU to sudb rw
sudb cirmir <<suid>|all> <cir dn> <cir up>
<mir dn> <mir up>
AP Change SU’s CIR/MIR settings rw
sudb defaultcirmir AP Display default CIR and MIR in sudb ro/rw
sudb defaultcirmir <cir_dn, 0..3000>
<cir_up, 0..3000> <mir_dn, 0..3000>
<mir_up, 0..3000>
AP Change default CIR and MIR rw
sudb defaultcirmir <default cir dn> <default
cir up> <default mir dn> <default mir up>
AP Set MIR/CIR values to default values rw
sudb delete <<suid>|all> AP Delete SU in sudb rw
sudb dload AP Download SU database file from TFTP buffer and write to
flash memory, This command is used to load a text file which
contains the SU database into the AP. This command can be
useful if there are large numbers of SUs in the sector.
rw
sudb gid <suid>|all> <0..15> AP Change su’s gid rw
sudb view AP Display all sudb ro/rw
survey <search time, sec> <antenna, h | v |
e>
AP/SU Spectrum analysis of the entire band (and near band)
<search time> = 1..10 sec per channel
Opmode OFF only
ro/rw
sw AP/SU Display current sw setting ro/rw
sw 0 [on | off] AP/SU set sw #0 – enable or disable packet filter for broadcast/
multicast packets
on = filtering
default = on
rw
sw 1 [on | off] SU Enable or disable SU’s autoscan AP feature
If on, SU will automatically scan each channel and antenna
port searching for AP.
default=on
rw
sw 2 [on | off] SU Enable or disable SU’s TCP/IP service for ap
Allows TCP/IP access to SU from AP side of network via
wireless link.
default = on
rw
sw 3 [on | off] AP Enable or disable SU to SU (peer to peer) service
default = off
rw
sw 5 [on | off] AP/SU Enable or disable httpd (browser interface)
default = on
rw
sw 6 [on | off] SU Enable or disable tcp/ip service for Ethernet port while SU is in
opmode ON.
default = on
rw
sw 7 [on | off] AP Enable or disable tcp/ip service for SU. Allows TCP/IP access
to AP from SU side of network via wireless link.
default = on
rw
sysinfo AP/SU Display system configuration ro/rw