User's Manual

Trango Broadband Wireless — User Manual M2400S Rev. A
Page 42
Command Radio Description Access
Note: SU’s power will be adjusted by AP during association
process (power levelling)
pppoeonly SU Display current PPPoE filter setting ro/rw
pppoeonly <on | off> SU Change PPPoE filter setting
With PPPoE filter set to ON, only PPPoE packets will pass
Default: off – Pass All Packets
rw
reboot AP/SU Reboot unit ro/rw
remarks AP/SU Display remarks ro/rw
remarks <str,31 octs> AP/SU Overwrite remarks rw
reset AP/SU Reset radio’s system settings back to factory defaults, then
reboot
rw
rfrxth AP/SU Display current RF Rx Threshold ro/rw
rfrxth <-98..-55> AP/SU Change current RF Rx Threshold
default = -98 dBm
rw
rssi AP/SU Display current Rx rssi
Opmode OFF only on AP
ro/rw
save <mainimage | fpgaimage> <<current
chscksum>> <<new checksum>>
AP/SU Save new firmware. This command gets new firmware image
from tftp buffer, verifies checksum and writes to flash memory
at main or fpga image section.
rw
save <sudb> AP Save SU dbase into flash memory rw
save <systemsetting | ss> AP/SU Save current configuration into flash memory rw
set apid <ap-id> AP Set AP ID, <ap-id> = 1..255 rw
set baseid <base-id, 4 oct> AP/SU Set base station id Baseid = XXXX where X = any
alphanumeric character except “/”
rw
set defaultopmode <on | off> AP/SU Set default opmode to ON or OFF.
Factory set default opmode is OFF.
rw
set httpport [<port #>] AP/SU Set or display HTTPD port number
port # = 1..65534
default port = 80
rw
set snmpcomm <read | write | trap id# |trap
all>
AP/SU Set SNMP read or write or trap community string rw
set telnetport [<port #>] AP/SU Specify telnet port, <port #> = 1..65534
Default port = 23
rw
snmpsample <min, 1..60> AP/SU Set SNMP sample period rw
su password <suid | all> <rw | ro> <new
password> <new password>
AP Change read/write or read-only password of all or a specific
subscriber
rw
su <all | suid> AP Display all or specific su information in dbase ro/rw
su info <suid> AP Command issued from the AP to gather information about
specific SUs.
1. distance
2. rssi at ap
3. rssi at su
4. IP address
5. Subnet address
6. Gateway address
7. Device ID
8. Hardware version
9. FPGA version
10. FPGA checksum
11. Firmware version
12. Firmware checksum
13. Firmware datecode
14. broadcast/multicast packet filter on/off
15. auto scan ap on/off
16. tcpip for ap on/off
17. httpd on/off
ro/rw