User's Manual
Basic Configuration via CLI
Trango Broadband Wireless — User Manual M2400S Rev A
Page
26
SU SYSTEM INFORMATION PARAMETERS AND RELATED COMMANDS
SU Parameter Description Related CLI Command
Opmode Current Opmode of radio.
opmode on y - set opmode to ON. (note:
“y” is necessary if default opmode is OFF.
opmode off – set opmode to OFF.
Default Opmode Determines the Opmode
(“ON” or “OFF”) of the
radio after power cycle.
When the parameter is set
to “ON”, the radio will
progress into “ON”
Opmode automatically
after reboot/power cycle.
set defaultopmode <on or off>
Example:
#>set defaultopmode on
IP
Subnet
Gateway
IP, Subnet, and Gateway
address of radio.
ipconfig [<new ip> <new subnet mask>
<new gateway>]
Example:
#>ipconfig 10.1.1.3 255.0.0.0 10.1.1.1
Tftpd Tftpd status (on or off).
Tftpd should be turned on
to import file into radio
(such as new firmware).
Default is off. TFTPD will
revert to Off after
rebooting.
tftpd <on|off>
Example:
#>tftpd on
RF Tx Power Current transmit power of
the SU not including
antenna gain. This is
controlled by the AP.
Informational Parameter only – can not be
manually changed by user.
Active Channel Shows the channel used
in the current association,
and "Associated" or
"Disconnected" depending
on the association status.
If Autoscan AP (SW 1) is on, the active
channel (and antenna selection) will be set
once the SU scans and begins the association
process with an AP.
If Autoscan AP is off, active channel is set by
user using the freq and antenna commands.
freq [<ch#>]
Use this command to change the channel.
antenna [h | v |e]
Use the antenna command to select active antenna
Broadcast Packet Filter The software switch (0)
enables/disables the
blocking of Ethernet
control packets except
ICMP and ARP to reduce
the amount of
unnecessary overhead
introduced to the wireless
link. Default setting is ON.
sw <sw#>=0..7 [on|off]
Example:
#>sw 0 on
AP Autoscan This software switch
(switch 1) is to turn AP
autoscan on or off.
sw 1 [on|off] (default is on)
(for SUs only)
TCP/IP for AP The software switch (2)
when on, allows users at
the AP side of the network
sw 2 [on|off] (default is on)
Example: