User's Manual
Basic Configuration via CLI
Trango Broadband Wireless — User Manual M2400S Rev A
Page
25
Subscriber Unit Basic Settings
Once logged on to the SU you can receive a comprehensive snapshot of the system’s configuration info
and status, by typing the command sysinfo.
#> sysinfo
[Hardware Version] 0006
[FPGA Version] 04042201 [Checksum] 47231EEE
[Firmware Version] SU 1p0x8H0006D04061502 [Checksum] 6DDF232C
[Device ID] 00 01 DE 19 F0 A4 [S/N] 01700004
[Base ID] 1234 [AP ID] 01 [SU ID] 1
[System Up Time] 0 day(s) 05:14:51
[Opmode] on [Default Opmode] on
[IP] 10.8.1.234 [Subnet Mask] 255.255.255.192 [Gateway] 10.8.1.193
[Login Password] RW
[Httpd Port] 80 [Httpd Status] listen
[Telnetd Port] 23 [Telnetd Status] connected (10.8.0.60,1738)
[Tftpd] disabled
'[RF Tx Power] 22 dBm
[RF Rx Threshold] -98 dBm
[Ch#01] 2405 Mhz [Ch#02] 2415 Mhz [Ch#03] 2425 Mhz [Ch#04] 2435 Mhz
[Ch#05] 2445 Mhz [Ch#06] 2455 Mhz [Ch#07] 2465 Mhz [Ch#08] 2475 Mhz
[Default Channel] 1 h [Active Channel] 1 v [Associated] Y
[Broadcast Packet] block [Auto Scan AP] on [TCP/IP for AP] on [TCP/IP for Local
Eth] on
[Remarks]
[RF Rx] 3 kbps [RF Tx] 2 kbps [Eth Rx] 0 kbps [Eth Tx] 0 kbps
[ARQ RF Tx Retry] 0 [ARQ RF Tx Retry Maxed Out] 0
Many of these parameters can be changed by the user. A description of each of these changeable
parameters, along with the related command is shown in the table below.
!
Important! When changing settings, it is usually necessary to type the save ss command in order
to update the radio’s flash memory. If you do not type the save ss command, the setting will be lost
the next time the radio is rebooted.
SU SYSTEM INFORMATION PARAMETERS AND RELATED COMMANDS
SU Parameter Description Related CLI Command
Device ID MAC Address of the SU N/A
Base ID Specifies the cell or cluster
to which the SU belongs.
set baseid <baseid>
Example:
#>Set baseid aa12
Target AP If a unique AP ID is
selected, the SU will only
associate with specified
target AP. If ALL is
selected, SU can
associate with any AP with
a matching BASE ID.
targetap <apid>
Examples:
#>targetap 33
#>targetap all