User's Manual
Basic Configuration via CLI
Trango Broadband Wireless — User Manual M2400S Rev A
Page
23
AP SYSTEM INFORMATION PARAMETERS AND RELATED COMMANDS
AP Parameter Description Related CLI Command
RF Rx Threshold Specifies the receiver
sensitivity of the AP. It is a
powerful tool when the radio
is in a noisy environment.
AP will block out any signal
received which is below the
RF Rx threshold.
rfrxth <-90..-55>
example:
#>rfrxth –70
RF Tx Power Current transmit power of
the AP not including antenna
gain.
power <set> <min|max|<dBm>>
Example:
#>power set 10
Channel Table Assigned frequencies to
channels. All channels may
be re-assigned as desired by
the administrator.
freq writechannel [<ch#> <freq>]
Example:
#>freg writechannel 3 2475
This command will change channel 3 to 2475
Mhz.
Broadcast Packet
Filter
This software switch (switch
0) enables/disables the
blocking of Ethernet control
packets except ICMP and
ARP to reduce the amount of
unnecessary overhead
introduced into the wireless
link
sw 0 [on|off] (default is on)
Example:
#>sw 0 on
note: All switch settings (0-7) are set using the
sw on/off command.
SU to SU This software switch (switch
3) enables/disables the SU
to SU feature. When SU to
SU is turned on, multiple
SUs within the same sector
(meaning associated to the
same AP) can communicate
with each other. SUs using
SU to SU communication
must be on the same subnet.
sw 3 [on|off] (default is off)
Example:
#>sw 3 on
TCP/IP for SU This software switch (switch
7) when on, allows users at
the SU side of the network to
telnet or HTTP into the AP.
sw 7 [on|off] (default is on)
Example:
#>sw 7 off
Remarks User definable radio
information (i.e. customer
name, address of
installation, and so on). A
maximum of 28 characters
can be stored.
remarks [remarks]
Example:
#>remarks 123 Elm Street
Subscriber Unit Database Settings
Once you are familiar with the basic system information presented above, you are ready to add one or
more SUs to the SU database. There are five basic commands related to the SU database: sudb add,
sudb cirmir, sudb defaultcirmir, sudb view, and save sudb.
Adding an SU
You will need to know the following information to add an SU to the database: