User's Manual

Basic Configuration via Browser Interface
Trango Broadband Wireless — User Manual M2400S Rev A
Page
13
5. CIR up (SU to AP Committed Information Rate) is the minimum upstream bandwidth for the SU
in Kbps.
6. CIR dn (AP to SU Committed Information Rate) is the minimum downstream bandwidth for the
SU in Kbps.
7. MIR up (SU to AP Maximum Information Rate) is the maximum upstream bandwidth for the SU
in Kbps.
8. MIR dn (AP to SU Maximum Information Rate) is the maximum downstream bandwidth for the
SU in Kbps.
9. Enter the Device ID (MAC Address of the SU)
10. Save and Activate changes
!
Important! Always remember to Save and Activate changes or the SUDB will revert back to its
previous state after a power cycle or reboot.
!
Important! SUs using SU to SU communication must be on the same subnet.
Configure Other Basic AP Parameters
In addition to setting up the SU in the SU Database, the following settings from the AP’s Configuration
page must be set (or left at default).
Base ID: Four characters, alphanumeric, user definable base station ID. Input of BASEID shall be in
the format of xxxx. Where x is any character from the set : { 0..9; a..z; A..Z;
'!@#$%^&*()_+[]\<>,./?' } . The Base ID is typically assigned to a single AP or a group of
APs at a particular cell site. The Base ID in the AP must match the Base ID in the SU in
order for a link to be established. This parameter can only be changed while opmode is
"OFF".
AP ID: User definable AP ID (00-FF). Default is last two digits of MAC ID. Once authenticated,
the AP will automatically assign its AP ID to the SU. This parameter can only be changed
while opmode is “OFF”.
IP Address, Subnet Mask, Gateway:
The IP address used on the radio is for management purposes only. Since this is a layer-
II device, these parameters do not play a role in establishing the wireless link.
Default Opmode:
Will initiate Operation Mode of the radio after a power cycle or reboot. When the radio
enters "ON" mode, it will be transmitting. When the radio enters "OFF" mode, it will not be
transmitting. The radio can be put into opmode "OFF" regardless of its default opmode by
telnetting into the radio within the first 30 seconds after a power cycle or reboot.
Active Channel/Polarization:
Is the current channel and antenna polarization of the unit when Opmode = "ON".
To configure the AP’s other basic settings, complete the following steps:
1. Connect to the AP (see Getting Started) and open the Configuration page.