User's Manual
Table Of Contents
- Chapter 1: Overview
- Chapter 2: Status Tab
- Chapter 3: System Tab
- Chapter 4: Services Tab
- Chapter 5: Network Tab
- Chapter 6: Final Notes
- Glossary
- FCC Information
- Warranty Information
Altum AC 600 User Manual LT-9064 Rev A 7
The default credentials are:
Username: admin
Password: trango
1.6 Operating Modes
The radio can operate in the following modes:
1. Access Point / Master.
2. Station / Client.
3. Access Point WDS.
4. Station WDS.
A wide area network (WAN) is a network that covers a
broad area. The world's most popular WAN is the
Internet.
In a commonly used setup, the WAN port of an access
point connects to a modem via an Ethernet cable. A
modem can be a cable, digital subscriber line (DSL), or
fiber optic modem. A modem translates the signal
from the internet service provider (ISP) to Ethernet
signals that the access point can understand. This
allows the access point to have internet connection.
Other devices called stations connect wirelessly to
this access point. These devices can be other Altum
radios, mobile phones, printers, IP cameras, laptops.
The stations obtain internet connection from the
access point.
An access point WDS and a station WDS together
extend the wireless coverage, like a repeater. More
information on the setup can be found on page 28.
1.7 Buttons and Changes
The buttons are described below.
Reset: Undo the changes.
Save: Saves the changes. Currently please do not use
this button.
Save & Apply: Saves and applies the changes. Please
use this button instead of the 'Save' button so that
the changes would be applied immediately. It is
recommended to click this button before moving to a
different page.
Logout: Logs out of the radio's web page.
Note: At the top right corner of the radio's
configuration web page, there may be either of the
following texts displayed.
Changes: 0: Means that all changes on the
configuration web page have been applied to the
radio.
Unsaved Changes: Shows the number of changes that
have not yet been implemented in FLASH via the Save
& Apply button.
1.8 Physical Hardware Button
Please refer to Section 3.6.
1.9 LEDs
The light emitting diodes (LEDs) on the board are
described in Section 3.5 .
Figure 2: The login page is presented upon
requesting the radio's IP address.