User's Manual

Altum AC 600 User Manual LT-9064 Rev A 37
6.1.4 Mobile phone connects but cannot
access Internet
A mobile phone or any connected Wifi user would
not be able to access the Internet if the default
gateway is not set correctly on the radio.
The option for the default gateway is found in
Network → Interfaces → LAN → Common
Configuration → General Setup → IPv4 gateway.
If this radio has enabled a DHCP server but the
gateway is at a different IP address please add a DHCP
option according to Section 5.2.2 .
The DNS server should also be set. This option is
found in Network → Interfaces → LAN → Common
Configuration → General Setup → Use custom DNS
servers.
6.1.5 Unresponsive web page
Symptom: The 'XML Parsing Error' may occur if a
certain option was changed and the web page did not
update in time.
Solution: Re-enter the IP address into the browser.
This would bring you back to the login page of the
device.
6.1.6 Unresponsive
Symptom: The radio does not respond.
Solution: Turn off the radio for 10 seconds and then
turn it on again.
6.2 Resetting to factory default
To reset the radio to the factory default settings,
while the power is on, hold down the reset button for
8 seconds and then release.
Another method is to enter the following command
into the radio's Linux terminal:
• mtd -r erase rootfs_data
After a while, the flash would be erased and the radio
would reboot into its factory default state. The
firmware version remains the same as the latest
firmware loaded onto the board.
Figure 71: XML Parsing Error.